Filter
Top Products
2-75
Master Effects Memory (E-MEM) Subpanel
The PUT button provides a method of copying or “putting” the
contents of the Current Register into another
E-MEM register. If multiple keyframes are contained in the
enabled levels of the Current Register, they are copied into the
new register.
The PUT button is at low tally whenever a Put operation is
permissible and off when the operation is not permissible (no
Current Register).
When pressed, the PUT button high-tallies and the E-MEM
readout provides a prompt. For example, if a register in Bank 0 is
currently selected, the display will prompt:
PUT CUR INTO 0x?
To put the current effect into a specific bank and register, change
the bank number if the correct bank is not already selected, then
enter the destination register number. Press ENTER to confirm the
Put operation.
The Put operation does not copy sequence link information
(sequence link register or sequence delay) to the destination
register.
If the destination register is locked, the Put operation will not be
performed, an error beep will sound, and the keypad readout will
show “REG IS LOCKED”.
An Undo of the Put operation will restore the previous contents to
the destination register, without affecting the Current Switcher
State or changing the Current Register number.
Also, as mentioned previously, the PUT button may be used to
copy the Current Register contents into the next empty register by
pressing PUT • ENTER.
PUT