Filter
Top Products
100 3Com Router 5000/6000 Family
Command Reference
motorola base-svc
Use the motorola base-svc command to configure the start SVC for voice routing on a DLCI.
DLCI view
motorola encapsulation
Use the motorola encapsulation command to specify an encapsulation for Motorola LCON on the DLCI.
DLCI view
motorola max-voice
Use the motorola max-voice command to configure the maximum number of voice channels created on a
DLCI concurrently.
DLCI view
motorola remote-id
Use the motorola remote-id command to configure a remote connection ID.
DLCI view
move
Use the move command to move a file.
User view
mpls
Use the mpls command in system view to enable MPLS globally and enter MPLS view.
Use the
mpls command in interface view to enable MPLS on the interface.
Interface view
Routing Protocol view
System view
Virtual Interface view
mpls l2vc
Use the mpls l2vc command to create an LDP connection.
Interface view
mpls l2vpn
Use the mpls l2vpn command to enable L2VPN.
System view
mpls l2vpn encapsulation
Use the mpls l2vpn encapsulation command to create Kompella MPLS L2VPN, specify encapsulation
type, and enter MPLS L2VPN view.
System view
mpls-exp
Use the mpls-exp command to configure the PVC to carry packets of the specified priority levels when the
EXP identifier in the MPLS packet is used to identify the priority levels of packets.
ATM Pvc-Group view
mpls label advertise
Use the mpls label advertise command to specify at the egress the type of the label to be distributed to
the penultimate hop.
MPLS view
mpls ldp
Use the mpls ldp command to enable LDP.
System view
mpls ldp enable
Use the mpls ldp enable command to enable LDP on the interface.
Interface view
mpls ldp hops-count
Use the mpls ldp hops-count command to set the maximum hops of loop detection.
System view
mpls ldp loop-detect
Use the mpls ldp loop-detect command to enable loop detection.
System view
mpls ldp password
Use the mpls ldp password command to configure LDP authentication mode.
Interface view
Remote-Peer view