Filter
Top Products
3Com Router 5000/6000 Family 103
Command Reference
nat outbound static
Use the nat outbound static command to apply on the interface one-to-one address translation
configured using the
nat static command.
Interface view
nat overlapaddress
Use the nat overlapaddress command to map an overlapping address pool to a temporary address pool.
System view
nat server
Use the nat server command to define a mapping table for internal servers. Users can access the internal
server with the address and port as host-addr and host-port respectively through the address port defined
by global-addr and global-port.
Interface view
nat static
Use the nat static command to configure a one-to-one private-to-public address binding.
System view
nat static inside
Use the nat static inside command to create a static net-to-net NAT entry. When the router translates
addresses based on this type of NAT entry, it translates the network address portion without touching the
host address portion.
System view
nat traversal
Use the nat traversal command to configure the NAT traversal function of IKE/IPSec.
IKE-Peer view
national-bit
Use the national-bit command to configure national bit on the CE3 interface.
CE3 Interface view
naturemask-arp
Use the naturemask-arp enable command to support ARP within natural network segments rather than
subnets.
System view
nbns-list
Use the nbns-list command to configure NetBIOS server addresses in a global DHCP address pool for
the clients.
DHCP Address Pool view
nesting
Use the nesting command to configure a nesting rule.
ACL view
netbios-type
Use the netbios-type command to configure the NetBIOS node type of the clients of a global DHCP
address pool.
DHCP Address Pool view
network
Use the network command to configure the network routes advertised by the local BGP system.
BGP view
network
Use the network command to configure an IP address range used for dynamic allocation.
DHCP Address Pool view
network
Use the network command to configure the network addresses to be sent by the local BGP.
IPv4 Multicast Subaddress Family view
network
Use the network command to configure the interface running OSPF.
OSPF Area view
network
Use the network command to enable Routing Information Protocol (RIP) on the interface.
RIP view