Filter
Top Products
106 3Com Router 5000/6000 Family
Command Reference
ospf
Use the ospf command to enable the OSPF protocol.
System view
ospf authentication-mode
Use the ospf authentication-mode command to configure the authentication mode and key between
adjacent routers.
Interface view
ospf cost
Use the ospf cost command to configure different packet sending costs so as to send packets from
different interfaces.
Interface view
ospf dr-priority
Use the ospf dr-priority command to configure the priority for electing the "designated router" on an
interface.
Interface view
ospf mib-binding
Use the ospf mib-binding command, MIB operation can be bound on the specified OSPF process.
System view
ospf mtu-enable
Use the ospf mtu-enable command to enable the interface to write MTU value when sending DD packets.
Interface view
ospf network-type
Use the ospf network-type command to configure the network type of OSPF interface.
Interface view
ospf timer dead
Use the ospf timer dead command to configure the dead interval of the OSPF neighbor.
Interface view
ospf timer hello
Use the ospf timer hello command to configure the interval for transmitting Hello messages on an
interface.
Interface view
ospf timer poll
Use the ospf timer poll command to configure the poll Hello message interval on nbma and p2mp
network.
Interface view
ospf timer retransmit
Use the ospf timer retransmit command to configure the interval for LSA re-transmitting on an interface.
Interface view
ospf trans-delay
Use the ospf trans-delay command to configure the LSA transmitting delay on an interface.
Interface view
ospf vpn instance
Use the ospf command to enable an OSPF process.
System view
option
Use the option command to specify the logical relationship between the addresses to be probed in the
detect group.
Detect Group view
outband
Use the outband command to configure transmission of DTMF code in the outband mode.
Voice Entity view
outband vofr
Use the outband vofr command to configure out-of-band transmission of DTMF codes.
Voice Entity view
overlap voip h323
Use the overlap voip h323 command to configure the calling party to support h323 overlap mode for
sending numbers.
Voice Dial Program view