Filter
Top Products
3Com Router 5000/6000 Family 145
Command Reference
stopbits
Use the stopbits command to set the stop bits on the user interface.
User Interface view
stub
Use the stub command to configure the type of an OSPF area as the STUB area.
OSPF Area view
subscriber-line
Use the subscriber-line command to enter the voice subscriber-line view.
Voice view
subscriber-line
Use the subscriber-line command to enter FXS, FXO, analog E&M, or digital E1/T1 voice subscriber-line
view.
Any Voice view except for Voice Entity view
substitute
Use the substitute command to bind the calling/called number-substitute list to the voice subscriber-line
or voice entity.
Voice Entity View
Voice Subscriber-Line view
substitute incoming-call
Use the substitute incoming-call command to bind the calling/called numbers of the incoming calls
from the network side to the number-substitute list.
Voice Dial Program view
substitute outgoing-call
Use the substitute outgoing-call command to bind the calling/called numbers of the outgoing calls from
the network side to the number-substitute list.
Voice Dial Program view
summary
Use the summary command to configure automatic aggregation of sub-network routes.
BGP Multicast view
BGP Unicast view
VPN Instance view
summary
Use the summary command to configure IS-IS route summary.
IS-IS view
summary
Use the summary command to enable RIP-2 automatic route summarization.
RIP view
super
Use the super command to switch the current user level to a specified user level, or the command level that
the user can access.
User view
super authentication mode
Use the super authentication-mode command to configure authentication mode for the super command,
which can be configured to the following four modes:
User Interface view
super password
Use the super password command to set the password needed to switch from a lower user level to a higher
one.
System view
sync-clock enable
Use the sync-clock enable command to enable clock synchronization between the router and the OSM
board.
GigabitEthernet Interface view
sync-clock interval
Use the sync-clock interval command to set clock synchronization interval between the router and the
OSM board.
GigabitEthernet Interface view
synchronize arp
Use the synchronize arp command to enable authorized ARP for global DHCP address pools.
Global DHCP Address Pool view