Filter
Top Products
72 3Com Router 5000/6000 Family
Command Reference
fr lmi t392dce
Use the fr lmi t392dce command to set T392 parameter at the DCE side.
Interface view
fr lmi type
Use the fr lmi type command to configure the Frame Relay LMI protocol type.
Interface view
fr map bridge
Use the fr map bridge command to add a bridge-set to frame relay map entry.
Interface view
fr map clns
Use the fr map clns command to add an FR mapping for OSI packets.
Interface view
fr map ip
Use the fr map ip command to add an IP address map entry for FR.
Interface view
fr map ipx
Use the fr map ipx command to add an IPX address map entry.
Interface view
fr map ppp interface virtual-template
Use the fr map ppp interface virtual-template command to map the FR DLCI (corresponds to an FR
PVC) to a PPP link, so the PPPoFR link is established, and thus PPP packets can be sent/received on FR
PVC.
Interface view
fr match
Use the fr match command to configure a PVC group to differentiate traffic by the Precedence or DSCP
identifier in the TOS field of the IP header.
FR Pvc-Group view
fr mpls-exp
Use the fr mpls-exp command to configure the PVC to carry packets of the specified priority levels when
the EXP identifier in the MPLS packet is used to identify the priority levels of packets.
FR Pvc-Group view
fr pvc-group
Use the fr pvc-group command to create a PVC group.
Interface view
fr pvc-pq
Use the fr pvc-pq command to set the queue type of a frame relay interface as PVC PQ (PVC Priority
Queuing) and set queue length, i.e. the maximum number of packets that can be held by a queue, for each
queue.
Frame Relay Interface view
MFR Interface view
fr pvc-protect
Use the fr pvc-protect command to configure the protection mode for a PVC in a PVC group.
FR Pvc-Group view
fr switch
Use the fr switch command to create a PVC used for frame relay switching and enter frame relay
switching view.
System view
fr switching
Use the fr switching command to enable frame relay PVC switching.
System view
fr traffic-policing
Use the fr traffic-policing command to enable FRTP function.
Frame Relay Interface view
MFR Interface view
fr traffic-shaping
Use the fr traffic-shaping command to enable FRTS function.
Frame Relay Interface view
MFR Interface view