Filter
Top Products
3Com Router 5000/6000 Family 91
Command Reference
isdn statistics
Use the isdn statistics command to have the system make statistics on the information received and
transmitted at an ISDN interface.
Use the
isdn statistics start command in the view of an interface to start making statistics on the
messages received and transmitted at the interface.
Use the
isdn statistics display command to view the statistic information.
Use the
isdn statistics continue command to continue the effort in making statistics.
Use the
isdn statistics display flow command to view the statistics in the form of flow.
Use the
isdn statistics stop command to stop making statistics.
ISDN Interface view
isdn two-tei
Use the isdn two-tei command to have the router requests the connected switch for a new TEI value
before calling for a B channel.
BRI Interface view
isis
Use the isis command to enable the corresponding IS-IS routing process and enter the IS-IS view.
System view
isis authentication-mode
Use the isis authentication-mode command to configure the IS-IS to authenticate the hello messages
of the corresponding level, in the specified mode and with the specified password on the IS-IS interface.
Interface view
isis circuit-level
Use the isis circuit-level command to configure the link adjacency relationship.
Interface view
isis cost
Use the isis cost command to configure the link cost of this interface when performing SPF calculation.
Interface view
isis dis-priority
Use the isis dis-priority command to configure the priority of an interface for the corresponding level
DIS election.
Interface view
isis enable
Use the isis enable command to configure this interface to activate the corresponding IS-IS routing
process.
Interface view
isis enable clns
Use the isis enable clns command to enable CLNS-based IS-IS routing process for a specified interface.
Interface view
isis mesh-group
Use the isis mesh-group command to add an interface to a specified mesh group.
Interface view
isis small-hello
Use the isis small-hello command to disable IS-IS to stuff Hello packets to the size of interface MTU if
their data sizes are smaller.
Interface view
isis timer csnp
Use the isis timer csnp command to configure the interval of sending CSNP packets on the broadcast
network.
Interface view
isis timer hello
Use the isis timer hello command to configure the interval of sending hello message of corresponding
level.
Interface view
isis timer holding-multiplier
Use the isis timer holding-multiplier command to configure the number of invalid Hello messages
for the interface.
Interface view