Filter
Top Products
3Com Router 5000/6000 Family 69
Command Reference
filter-policy import
Use the filter-policy gateway import command to filter the learned routing information advertised by
the specified address.
Use the
filter-policy import command to filter the received global routing information.
BGP Unicast view
BGP Multicast view
VPNv4 view
VPN Instance view
filter-policy import
Use the filter-policy import command to configure to filter the routes received by IS-IS.
IS-IS view
filter-policy import
Use the filter-policy import command to configure the OSPF rules of filtering the routing information
received.
Use the
filter-policy import command to filter the routes calculated by OSPF. Only the filtered routes
can be added to the routing table. The filtering can be performed according to the next hop and destination
of the route.
OSPF view
filter-policy import
Use the filter-policy gateway command to configure to filter the received routing information distributed
from the specified address.
Use the
filter-policy import command to configure the filtering to the received global routing
information.
RIP view
final-callednum
Use the final-callednum command to enable or disable the terminate signal to be sent to the terminating
point after the called number is sent.
R2 CAS view
firewall aspf
Use the firewall aspf command to apply ASPF policy in specified direction to an interface.
Interface view
firewall default
Use the firewall default command to configure the default filtering rule of the firewall, whether to be
“permit” or “deny”.
System view
firewall enable
Use the firewall enable command to enable the firewall.
System view
firewall ethernet-frame-filter
Use the firewall ethernet-frame-filter command to apply a MAC-based ACL on the interface.
Interface view
firewall fragments-inspect
Use the firewall fragments-inspect command to enable fragment inspection switch.
System view
firewall fragments-inspect {high | low}
Use the firewall fragments-inspect { high | low } command to configure the high and low thresholds
of records for fragment inspection.
System view
firewall packet-filter
Use the firewall packet-filter command to apply the access control list to the corresponding interface.
Interface view
first-rule
Use the first-rule command to configure the number-substitute rule that is first used in the current
number-substitute list.
Voice Number-Substitute view
fixdisk
Use the fixdisk command to restore the space of a storage device when it becomes unavailable because
of some abnormal operation.
User view