Filter
Top Products
80 3Com Router 5000/6000 Family
Command Reference
igmp timer other-querier-present
Use the igmp timer other-querier-present command to configure the overtime value of presence of
IGMP querier.
Interface view
igmp timer query
Use the igmp timer query command to configure the interval at which a router interface sends IGMP query
messages.
Interface view
igmp version
Use the igmp version command to specify the version of IGMP that a router uses.
Interface view
ignore-lsp-checksum-error
Use the ignore-lsp-checksum-error command to configure the IS-IS to ignore the checksum error of
LSP.
IS-IS view
ike dpd
Use the ike dpd command to create a DPD structure and enter its view.
System view
ike local-name
Use the ike local-name command to set the name of the local GW.
System view
ike next-payload check disabled
Use the ike next-payload check disabled command to disable the router to check the next-payload field
in the last payload of the IKE negotiation packet during IPSec negotiation for compatibility with other
vendors.
System view
ike peer (IPSec Policy view or IPSec Policy Template view)
Use the ike peer command to quote an IKE peer in an IPSec policy or IPSec policy template.
IPSec Policy view
IPSec Policy Template view
ike peer (System view)
Use the ike peer command to configure an IKE peer and access IKE-peer view.
System view
ike proposal
Use the ike proposal command to define an IKE proposal.
System view
ike sa keepalive-timer interval
Use the ike sa keepalive-timer interval command to configure the interval for sending Keepalive
packet to the remote end through ISAKMP SA.
System view
ike sa keepalive-timer timeout
Use the ike sa keepalive-timer timeout command to configure a timeout for ISAKMP SA to wait for the
Keepalive packet.
System view
ike sa nat-keepalive-timer interval
Use the ike sa nat-keepalive-timer interval command to configure the NAT keepalive interval for IKE
peers.
System view
ima-clock
Use the ima-clock command to configure the clock mode of the IMA group.
IMA Group Interface view
ima ima-group
Use the ima ima-group command to add the ATM E1/T1 interface to the specified IMA group. If the
specified IMA group does not exist, it is created first.
ATM E1/T1 Interface view
ima-test
Use the ima-test command to set a test pattern for testing the connectivity of the specified link to the rest
of the IMA group.
IMA Group Interface view