Filter
Top Products
116 3Com Router 5000/6000 Family
Command Reference
pppoe-client
Use the pppoe-client command to establish a PPPoE session and specify the Dialer Bundle
corresponding to the session.
Ethernet Interface (subinterface) view
Virtual Ethernet Interface view
pppoe-server bind virtual-template
Use the pppoe-server bind virtual-template command to enable PPPoE on the virtual-template
specified by the Ethernet interface.
Interface view
pppoe-server log-information off
Use the pppoe-server log-information off command to enable the PPPoE server to output the
PPP-related log information.
System view
pppoe-server max-sessions local-mac
Use the pppoe-server max-sessions local-mac command to set the maximum number of PPPoE
sessions that can be established at a local MAC address.
System view
pppoe-server max-sessions remote-mac
Use the pppoe-server max-sessions remote-mac command to set the maximum number of PPPoE
sessions that can be established at a peer MAC address.
System view
pppoe-server max-sessions total
Use the pppoe-server max-sessions total command to set the maximum number of PPPoE sessions
that the system can establish.
System view
pq
Use the pq command to set the queue type of frame relay virtual circuit as Priority Queuing.
Frame Relay Class view
pre-shared-key
Use the pre-shared-key command to set the pre-shared key used when a client needs to authenticate a
DVPN server.
Dvpn-Class view
pre-shared-key
Use the pre-shared-key command to configure a pre-shared key to be used in IKE negotiation.
IKE-Peer view
preference
Use the preference command to configure the preference of BGP protocol.
BGP Protocol view
BGP Multicast Address Family view
preference
Use the preference command to configure the preference of IS-IS protocol.
IS-IS view
preference
Use the preference command to configure the preference of an OSPF protocol route.
OSPF view
preference
Use the preference command to configure the route preference of RIP.
RIP view
preference clns
Use the preference clns command to set the preference of the CLNS routes discovered by IS-IS protocol.
IS-IS view
pri-set
Use the pri-set command to bundle timeslots on the CT1/PRI or CE1/PRI interface into a pri-set.
CE1/PRI Interface view
CT1/PRI Interface view
pri-set (CE1/PRI Interface)
Use the pri-set command to have timeslots on the CE1/PRI interface form a pri-set.
CE1/PRI Interface view