Filter
Top Products
3Com Router 5000/6000 Family 65
Command Reference
dvpn service
Use the dvpn service enable command to enable DVPN on a device.
System view
e1 bert
Use the e1 bert command to set test error bit for line Bit on CE3 interface.
CE3 interface view
e1 channel-set
Use the e1 channel-set command to bundle timeslots on an E1 line.
CE3 Interface view
e1 channel-set
Use the e1 channel-set command to bundle multiple timeslots on an E1 channel into one channel set.
CPOS Interface view
e1 set clock
Use the e1 set clock command to set clocking of an E1 line on the CE3 interface.
CE3 Interface view
e1 set clock
Use the e1 set clock command to set the clock mode of the E1 channel.
CPOS Interface view
e1 set frame-format
Use the e1 set frame-format command to configure the frame format on an E1 line.
CE3 Interface view
e1 set frame-format
Use the e1 set frame-format command to set the frame format of an E1 channel.
CPOS Interface view
e1 set loopback
Use the e1 set loopback command to set the loopback mode of the specified E1 line on the E3 interface.
CE3 Interface view
e1 set loopback
Use the e1 set loopback command to configure the loopback mode of the E1 channel.
CPOS Interface view
e1 shutdown
Use the e1 shutdown command to shut down an E1 line on the CE3 interface.
CE3 Interface view
e1 shutdown
Use the e1 shutdown command to shut down an E1 channel.
CPOS Interface view
e1 unframed
Use the e1 unframed command to set an E1 line on a CE3 interface to work in unframed mode (E1 mode).
CE3 Interface view
e1 unframed
Use the e1 unframed command to set an E1 channel on the CPOS interface to unframed mode or E1 mode.
CPOS Interface view
early-media disable
Use the early-media disable command to disable early media negotiation.
SIP Client view
ebs
Use the ebs command to set EBS of frame relay virtual circuit.
Frame Relay Class view
echo-canceller
Use the echo-canceller command to configure echo-cancellation parameters.
Voice Subscriber-Line view
effect-time
Use the effect-time command to configure the debounce time of line signaling.
R2 CAS view
eliminate-pulse
Use the eliminate-pulse command to eliminate the pulses with a width less than 3.472us, increasing
signal reliability. This is useful when the line is seriously interfered.
Asynchronous Serial Interface view