Filter
Top Products
104 3Com Router 5000/6000 Family
Command Reference
network-entity
Use the network-entity command to configure the name of Network Entity Title (NET) of the IS-IS routing
process.
IS-IS view
normal-connect slow-h245
Use the normal-connect slow-h245 command to configure disabling the calling end from actively initiating
an H245 connection request to the called end before the called end is hooked off in voice entity view.
Use the
normal-connect slow-h245 command to disable the calling end from actively initiating an H245
connection request to the called end before the called end is hooked off in voice entity view.
VoIP Voice Entity view
nslookup type
Use the nslookup type command to resolve the specified IP address or domain name to a domain name
or IP address.
Any view
nssa
Use the nssa command to configure an area as NSSA area.
OSPF Area view
ntp-service access
Use the ntp-service access command to control access to the NTP service on the local device.
System view
ntp-service authentication enable
Use the ntp-service authentication enable command to enable NTP service ID authentication.
System view
ntp-service authentication-keyid
Use the ntp-service authentication-keyid command to set an NTP authentication key.
System view
ntp-service broadcast-client
Use the ntp-service broadcast-client command to configure NTP broadcast client mode.
Interface view
ntp-service broadcast-server
Use the ntp-service broadcast-server command to configure NTP broadcast server mode.
Interface view
ntp-service max-dynamic-sessions
Use the ntp-service max-dynamic-sessions command to set the number of sessions allowed by the local
device.
System view
ntp-service multicast-client
Use the ntp-service multicast-client command to configure NTP multicast client mode.
Interface view
ntp-service multicast-server
Use the ntp-service multicast-server command to configure NTP multicast server mode.
Interface view
ntp-service refclock-master
Use the ntp-service refclock-master command to set the local clock as the NTP master clock to provide
synchronization source.
System view
ntp-service reliable authentication-keyid
Use the ntp-service reliable authentication-keyid command to specify a reliable key.
System view
ntp-service source-interface
Use the ntp-service source-interface command to specify an interface for the local end to transmit NTP
messages.
System view
ntp-service unicast-peer
Use the ntp-service unicast-peer command to configure NTP peer mode.
System view
ntp-service unicast-server
Use the ntp-service unicast-server command to configure NTP server mode.
System view