Filter
Top Products
78 3Com Router 5000/6000 Family
Command Reference
if-match acl
Use the if-match acl command to set the match condition for IP address.
Route-Policy view
if-match acl
Use the if-match acl command to configure the IP address range to match the route-policy.
Routing Policy view
if-match any
Use the if-match any command to define the rule matching all packets.
Class view
if-match as-path
Use the if-match as-path command to filter BGP routing information.
Routing Policy view
if-match atmclp
Use the if-match atmclp command to create a cell loss priority (CLP) bit match rule defining that ATM cells
with CLP bit set to 1 are matched.
Use the
if-match not atmclp command to create a CLP bit match rule defining that ATM cells with CLP
bit set to 0 are matched.
Class view
if-match classifier
Use the if-match classifier command to define class-map match rule.
Class view
if-match community
Use the if-match community command to configure the community list number to be matched in
route-policy.
Routing Policy view
if-match cost
Use the if-match cost command to configure one of the matching rules of route-policy to match the cost
of the routing information.
Routing Policy view
if-match {destination-mac | source-mac}
Use the if-match { destination-mac | source-mac } command to define match rule of destination or source
MAC address.
Class view
if-match dot1p-cos
Use the if-match dot1p-cos command to define a COS field match rule for VLAN packets.
Class view
if-match dscp
Use the if-match dscp command to define an IP DSCP match rule.
Class view
if-match fr-de
Use the if-match fr-de command to define an FR DE matching rule.
Class view
if-match inbound-interface
Use the if-match inbound-interface command to define ingress interface match rule of a class.
Class view
if-match interface
Use the if-match interface command to match the route whose next hop is designated interface.
Routing Policy view
if-match ip next-hop
Use the if-match ip next-hop command to configure one of the match rules of route-policy on the next
hop address of the routing information.
Routing Policy view
if-match ip-precedence
Use the if-match ip-precedence command to define IP precedence match rule.
Class view
if-match ip-prefix
Use the if-match ip-prefix command to configure one of the match rules of route-policy on the IP
address range of the routing information.
Routing Policy view