Filter
Top Products
3Com Router 5000/6000 Family 149
Command Reference
timeout
Use the timeout command to configure a timeout time for a test.
HWPing Test Group view
timer (Digital E&M)
Use the timer command to configure the timeout values of the signals in the digital E&M signaling.
Digital E&M Voice Subscriber-Line view
timer configuration
Use the timer configuration command to set the interval to send ISH packets.
ES-IS view
timer-dial-interval
Use the timer dial-interval command to configure the timer that the system waits for a subscriber to
dial the next digit.
Voice Subscriber-Line view
timer dl (R2)
Use the timer dl command to configure the timeout value of line signals of R2 signaling.
R2 CAS view
timer dtmf (R2)
Use the timer dtmf command to configure the time interval for sending DTMF signals.
R2 CAS view
timer first-dial
Use the timer first-dial command to configure the timer that the system waiting for a subscriber to dial
the first digit.
Voice Subscriber-Line view
timer hold
Use the timer hold command to set the polling interval.
Interface view
timer hold
Use the timer hold command to configure the polling timer at the DTE side.
Interface view
timer hold
Use the timer hold command to set the timer to send keepalive packet.
Serial Interface view
timer holding
Use the timer holding command to set the holding time of the information ISH packets sent carry.
ES-IS view
timer keep-alive hold
Use the timer keep-alive hold command to configure the Keepalive and Holdtime timer of BGP.
BGP Unicast view
BGP Multicast view
VPNv4 view
VPN Instance view
timer loop
Use the timer loop command to set the auto detect interval, that is, the frequency for auto detect.
Detect Group view
timer lsp-max-age
Use the timer lsp-max-age command to configure the maximum lifetime of an LSP generated by the
current router.
IS-IS view
timer-lsp-refresh
Use the timer lsp-refresh command to configure the refresh interval of LSP.
IS-IS view
timer quiet
Use the timer quiet command to set the duration that the primary server must wait before it can resume
the active state.
RADIUS view
timer quiet
Use the timer quiet command to set the duration that a primary server must wait before it can resume the
active state.
TACACS+ view