Filter
Top Products
3Com Router 5000/6000 Family 89
Command Reference
ipx split-horizon
Use the ipx split-horizon command to enable split horizon on the current interface.
Interface view
ipx tick
Use the ipx tick command to configure the delay of interface sending IPX packets.
Interface view
ipx update-change-only
Use the ipx update-change-only command to enable trigger update on the current interface.
Interface view
is-level
Use the is-level command to configure the IS-IS level.
IS-IS view
isdn bch-local-manage
Use the isdn bch-local-manage command to enable local ISDN B channel management.
ISDN Interface view
isdn bch-select-way
Use the isdn bch-select-way command to set a B channel selection method.
ISDN Interface view
isdn caller-number
Use the isdn caller-number command to configure the range of the numbers that the router can receive.
ISDN Interface view
isdn calling
Use the isdn calling command to have the messages from a calling party to a called party carry the calling
number.
ISDN Interface view
isdn check-called-number
Use the isdn check-called-number command to configure the called number or subaddress that the
system should verify when receiving a digital call.
ISDN BRI Interface view
ISDN PRI Interface view
isdn crlength
Use the isdn crlength command to set length of the call reference used when a call is placed on an ISDN
interface.
ISDN Interface view
isdn ie passthrough
Use the isdn ie passthrough command to enable transparent transmission of some or all related
information elements and you can use this command to configure transparent transmission direction.
ISDN Interface view (not applicable on BRI Interface)
isdn ignore connect-ack
Use the isdn ignore connect-ack command to configure the router to switch the ISDN protocol state to
ACTIVE to start the data and voice service communications after sending a CONNECT message without
having to wait for a CONNECT ACK message.
ISDN Interface view
isdn ignore hlc
Use the isdn ignore hlc command to disable ISDN to carry the higher layer compatibility (HLC)
information element in the SETUP messages sent when placing voice calls.
ISDN Interface view
isdn ignore llc
Use the isdn ignore llc command to disable ISDN to carry the Lower Layer Compatibility (LLC)
information element in the SETUP messages sent when placing voice calls.
ISDN Interface view
isdn ignore sending-complete
Use the isdn ignore sending-complete command to configure the ISDN protocol to ignore the processing
on the Sending Complete Information Element.
ISDN Interface view
isdn L3-timer
Use the isdn L3-timer command to configure the duration of an ISDN L3 timer.
ISDN Interface view