Filter
Top Products
3Com Router 5000/6000 Family 143
Command Reference
ssh user service-type
Use the ssh user service-type command to specify service type for a user.
System View
ssh2
Use the ssh2 command to initiate a connection to the specified SSH server, and specify the preferred key
exchange algorithm, encryption algorithm and HMAC algorithm between the client and the server.
System view
ssh2 source-interface
Use the ssh2 source-interface command to specify a source interface, which must be an existing local
interface, for the SSH client. After that, the IP address of the specified interface is used as the source IP
address in each packet sent by the SSH client.
System view
ssh2 source-ip
Use the ssh2 source-ip command to specify a source IP address for the packets sent by the SSH client.
This IP address must be a local IP address.
System view
standby bandwidth
Use the standby bandwidth command to configure the actual bandwidth that the main interface uses in
backup load sharing.
Interface view
standby detect-group
Use the standby detect-group command to implement interface backup using the auto detect function.
Interface view
standby interface
Use the standby interface command to specify a physical interface to back up the interface.
Interface view
standby routing-group
Use the standby routing-group command to apply a dynamic routing standby group on the secondary
interface.
Dial Interface view
standby routing-rule
Use the standby routing-rule command to create a dynamic routing standby group and assign a
monitored network segment to it.
System view
standby threshold
Use the standby threshold command to configure backup load sharing on an interface or logical channel.
Interface view
standby timer delay
Use the standby timer delay command to set failover and fallback delays on the interface, avoiding
frequent switchover caused by instability of interface state.
Interface view
standby timer flow-check
Use the standby timer flow-check command to configure the interval for checking the traffic size on the
main interface.
Interface view
standby timer routing-disable
Use the standby timer routing-disable command to specify a delay for the secondary link to be
disconnected after the primary link goes up to avoid route oscillation.
Dial Interface view
start l2tp
Use the start l2tp command to specify conditions triggering the local end to place calls when it works as
L2TP LAC.
L2TP Group view
start l2tp tunnel
Use the start l2tp tunnel command to enable the L2TP LAC to start L2TP tunnel connection.
L2TP Group view
start script
Use the start-script command to configure executing the specified Modem script on an interface.
User view