Filter
Top Products
3Com Router 5000/6000 Family 77
Command Reference
hwatacacs change-password self
Use the hwtacacs change-password self command to enable the TACACS online user to change the
password.
User view
hwatacacs nas-ip
Use the hwtacacs nas-ip command to specify the source address of the hwtacacs packet sent from NAS.
System view
hwatacacs scheme
Use the hwtacacs scheme command to enter TACACS+ Server view. If the specified TACACS+ server
scheme does not exist, you can create a new TACACS+ scheme.
System view
hwping
Use the hwping command to create an HWPing test group.
System view
hwping-agent enable
Use the hwping-agent enable command to enable the HWPing client function.
System view
hwping-agent max-requests
Use the hwping-agent max-requests command to set the allowed maximum number of concurrent tests.
System view
hwping-server enable
Use the hwping-server enable command to enable HWPing Server.
System view
hwping-server tcpconnect
Use the hwping-server tcpconnect command to create a TCP listening service.
System view
hwping-server udpecho
Use the hwping-server udpecho command to create a UDP listening service.
System view
icmp redirect send
Use the icmp redirect send command to enable the sending of ICMP Redirect messages.
System view
id-type
Use the id-type command to select the type of ID used in IKE negotiation.
IKE-Peer view
idle-mark
Use the idle-mark command to set the line idle-mark of the synchronous serial interface to “FF”.
Synchronous Serial Interface view
idle-timeout
Use the idle-timeout command to set the idle-timeout timer. When it expires, the user connection is
disconnected.
User Interface view
idlecode (CE1/PRI Interface)
Use the idlecode command to set the line idle code on the CE1/PRI interface. Two types of line idle code
are available: 0x7e and 0xff.
CE1/PRI Interface view
idlecode (CT1/PRI Interface)
Use the idlecode command to set the line idle code on the CT1/PRI interface. Two types of line idle code
are available: 0x7e and 0xff.
CT1/PRI Interface view
if-match
Use the if-match command to define the match rule of a class.
Class view
if-match acl
Use the if-match acl command to define ACL match rule.
Class view
if-match acl
Use the if-match acl command to set conditions that multicast packets should meet in each policy node.
Route-Policy view