Filter
Top Products
126 3Com Router 5000/6000 Family
Command Reference
reset firewall ethernet-frame-filter
Use the reset firewall ethernet-frame-filter command to clear the ACL-based firewall statistics.
User view
reset firewall-statistics
Use the reset firewall-statistics command to clear the firewall statistics.
User view
reset fr inarp
Use the reset fr inarp command to clear the address mapping established by inverse ARP.
User view
reset hwatacs statistics
Use the reset hwtacacs statistics command to clear TACACS+ protocol statistics.reset hwtacacs
statistics
User view
reset igmp group
Use the reset igmp group command to delete the IGMP group joined on the interface. The deletion of the
group does not affect its joining again.
User view
reset ike sa
Use the reset ike sa command to delete the security tunnel set up by IKE.
User view
reset ip count
Use the reset ip count command to clear information that the IP Accounting retained about IP packets.
User view
reset ip fast-forwarding cache
Use the reset ip fast-forwarding cache command to reset the unicast fast forwarding cache.
User view
reset ip multicast-fast-forwarding cache
Use the reset ip multicast-fast-forwarding cache command to clear the multicast fast forwarding
cache. However, this command does not release the space occupied by the cache.
User view
reset ip netstream statistics
Use the reset ip netstream statistics command to age and export all stream statistics to clear the
NetStream cache.
User view
reset ip routing-table
Use the reset ip routing-table command to clear the routing table.
User view
reset ip statistics
Use the reset ip statistics command to clear the IP statistics information. In some special cases, it is
necessary to clear the IP statistics information and perform new statistics.
User view
reset ipsec sa
Use the reset ipsec sa command to delete an SA already set up (manually or through IKE negotiation).
If no parameter (remote, policy, parameters) is specified, all the SA will be deleted.
User view
reset ipsec statistics
Use the reset ipsec statistics command to clear IPSec message statistics, and set all the statistics to
zero.
User view
reset ipx routing-table statistics
The reset ipx routing-table statistics command is used to clear the statistical information of a
specified type of IPX route.
User view
reset ipx statistics
Use the reset ipx statistics command to clear IPX statistics by the system.
User view
reset isis all
Use the reset isis all command to reset all the IS-IS data.
User view