Filter
Top Products
3Com Router 5000/6000 Family 7
Command Reference
arp timer aging
Use the arp timer aging command to set the aging timer for dynamic ARP entries.
System view
asbr-summary
Use the asbr-summary command to configure summarization of redistributed routes by OSPF.
OSPF view
ascii
Use the ascii command to set the type of the transmitted data to ASCII.
FTP Client view
aspf-policy
Use the aspf-policy command to define an ASPF policy. For a defined policy, the policy can be invoked
through its policy number.
System view
async mode
Use the async mode command to set the operating mode of the asynchronous serial interface.
Asynchronous Serial Interface view
AUX Interface view
AM Interface view
async mode padpos
Use the async mode padpos command to configure a POSPAD access port.
Asynchronous Serial Interface view
AUX Interface view
async mode pos
Use the async mode pos pos-number command to create a POS access port in nontransparent
transmission and permanent TCP connection mode.
Asynchronous Serial Interface view
AM Interface view
FCM Interface view
AUX Interface view
async mode posapp
Use the async mode posapp command to configure the interface to operate in POS application mode.
Asynchronous Serial Interface view
AUX Interface view
atm-class
Use the atm-class command to apply a set of parameters (which are defined in ATM-Class) to an ATM
interface or a PVC.
Interface view
PVC view
atm class
Use the atm class command to create an ATM-Class and enter the ATM-Class view.
System view
atm-ctt
Use the atm-ctt command to set all interfaces on a board to transparent transmission.
ATM Interface view
atm-link check
Use the atm-link check command to have the protocol state of the ATM P2P subinterface changes
depending on whether the physical interface is up and whether a PVC is configured on the subinterface.
ATM P2P Subinterface view
authentication
Use the authentication command to configure an authentication scheme for the current ISP domain.
ISP Domain view
authentication
Use the authentication command to set the IP address, port number and shared key for the primary and
secondary RADIUS authentication servers.
RADIUS Scheme view
authentication
Use the authentication command to set the IP address, port number and shared key for the primary and
secondary TACACS+ authentication servers.
TACACS+ view