Filter
Top Products
3Com Router 5000/6000 Family 151
Command Reference
tracert
Use the tracert command to trace the gateways by which a packet passes from source to destination for
network connectivity test and fault location.
Any view
tracert clns
Use the tracert clns command to track the nodes along the route that leads to a specified destination.
Any view
traffic behavior
Use the traffic behavior command you can define a traffic behavior and enter the behavior view.
System view
traffic classifier
Use the traffic classifier command to define a class and enter the class view.
System view
traffic-policy
Use the traffic-policy command to associate a sub-policy to the behavior.
Traffic Behavior view
traffic-shaping adaptation
Use the traffic-shaping adaptation command to enable the adaptive traffic shaping function of frame
relay.
Frame Relay Class view
traffic-share-across-interface
Use the traffic-share-across-interface command to enable RIP to distribute traffic equally on multiple
interfaces using equal-cost routes.
RIP Protocol view
RIP MBGP Address Family view
transform
Use the transform command to set a security protocol used by a proposal.
IPSec Proposal view
translate ip
Use the translate ip command to configure an X2T forwarding route from IP network to X.25 network.
System view
translate x25
Use the translate x25 command to configure an X2T forwarding route from X.25 network to IP network.
System view
transmit gain
Use the transmit gain command to configure the voice subscriber-line output end gain value.
Voice Subscriber-Line view
transmit-priority
Use the transmit-priority command to assign a transmit priority to the ATM PVC associated with the
UBR, VBR-T, or VBR-NRT service. The higher priority PVC is allocated bandwidth before any other PVCs.
ATM PVC view
trunk-direction
Use the trunk-direction command to configure the E1 trunk direction.
R2 CAS view
trunk-id
Use the trunk-id command to configure the number that the local end dials to call the PSTN side in FRF.11
trunk mode.
Voice Entity view
ts
Use the ts command to maintain the trunk circuit of the specified timeslot.
R2 CAS view
ttl
Use the ttl command to configure TTL of ICMP test packets.
HWPing Test Group view
ttl expiration
Use the ttl expiration command to configure the router to forward ICMP responses by local IP routing
when the MPLS TTL expires.
MPLS view