Filter
Top Products
3Com Router 5000/6000 Family 159
Command Reference
x25 ignore called-address
Use the x25 ignore called-address command to enable it to ignore the X.121 address of the called DTE
when X.25 initiates calls.
Interface view
x25 ignore calling-address
Use the x25 ignore calling-address command to enable it to ignore the X.121 address of the calling
DTE when X.25 initiates calls.
Interface view
x25 local-cug
Use the x25 local-cug command to configure mapping from local CUG to network CUG and define its
suppression rule.
Interface view
x25 map
Use the x25 map command to set the address mapping between IP address used by LANs and X.121
address.
Interface view
x25 map bridge
Use the x25 map bridge command to map an X.121 address to a bridge-set.
Interface view
x25 map clns
Use the x25 map clns command to configure a CLNS address mapping for an X.121 address.
Interface view
x25 modulo
Use the x25 modulo command to set the window modulus of an X.25 interface.
Interface view
x25 packet-size
Use the x25 packet-size command to set the maximum input and output packet lengths of X.25 interface.
Interface view
x25 pvc
Use the x25 pvc command to configure one PVC route encapsulated with datagram.
Interface view
x25 pvc
Use the x25 pvc command to configure an X.25 PVC route.
Interface view
x25 qllc-switch
Use the X25 qllc-switch command to create a QLLC switching map entry, an association of X.121
address, MAC address of the SNA device, and local virtual MAC address.
Synchronous Serial Interface view
x25 queue-length
Use the x25 queue-length command to set the data queue length on X.25 VC.
Interface view
x25 receive-threshold
Use the x25 receive-threshold command to set the number of receivable maximum packets before X.25
sends the acknowledged packet.
Interface view
x25 response called-address
Use the x25 response called-address command to enable X.25 to carry the address information of the
called DTE in sending call reception packet.
Interface view
x25 response calling-address
Use the x25 response calling-address command to enable X.25 to carry the address information of the
calling DTE in sending call reception packet.
Interface view
x25 reverse-charge-accept
Use the x25 reverse-charge-accept command to enable this interface to accept the call with “reverse
charging request”, the information added by some certain user facilities.
Interface view