Filter
Top Products
3Com Router 5000/6000 Family 9
Command Reference
balance
Use the balance command to configure the number of routes participating in BGP load balancing.
BGP view
band-based-sharing
Use the band-based-sharing command to enable bandwidth-based unbalanced load sharing.
System view
baudrate
Use the baudrate command to set the baud rate of a serial interface.
Serial Interface view
bert
Use the bert command to set test error bit for line Bit.
CE3 interface view
bert (CT1/PRI Interface)
Use the bert command to start a BERT test on the CT1/PRI interface.
CT1/PRI Interface view
bert (CT3 Interface)
Use the bert command to start a BERT test on the CT3 interface.
CT3 Interface view
bgp
Use the bgp command to enable BGP and enter the BGP view.
System view
This command is used to enable and disable BGP as well as to specify the local AS number of BGP.
bims boot request
Use the bims boot request command to enable the BIMS device to access the branch intelligent
management system (BIMS) center at startup.
System view
bims device-id string
Use the bims device-id command to configure the unique identifier of the BIMS device at the BIMS center.
System view
bims enable
Use the bims enable command to enable BIMS.
System view
bims interval
Use the bims interval command to configure the interval for accessing the BIMS center. When the interval
is set to 0, the BIMS device does not access the BIMS center regularly.
System view
bims ip address
Use the bims ip address command to configure the IP address and port number of the BIMS center.
System view
bims request
Use the bims request command to have the BIMS device access the BIMS center.
System view
bims-server
Use the bims-server command to enable and configure BIMS option for a global address pool on the
DHCP server.
Global DHCP Address Pool view
bims sharekey
Use the bims sharekey command to configure the shared key between the BIMS device and the BIMS
center.
System view
bims source ip-address
Use the bims source ip-address command to specify a source IP address for the packets sent by the
BIMS device. It can be the IP address of a port on the router.
System view
bims specify-time
Use the bims specify-time command to configure the BIMS device to access the BIMS center at the
specified time and if desired, configure the device to access the BIMS center at regular intervals from then
on during a specified period.
System view