Filter
Top Products
120 3Com Router 5000/6000 Family
Command Reference
qos lr
Use the qos lr command to limit the transmitting rate of the interface.
Interface (including the MFR Interface) view
qos max-bandwidth
Use the qos max-bandwidth command to configure the maximum interface bandwidth used when CBQ
enqueues packets.
Interface view
qos policy
Use the qos policy command to define a policy and enter policy view.
System view
qos pq
Use the qos pq command to apply a group of priority list to an interface.
Interface view
qos pql default-queue
Use the qos pql default-queue command to designate the packets without corresponding rules to a
default queue.
System view
qos pql inbound-interface
Use the qos pql inbound-interface command to establish classification rules based on interfaces.
System view
qos pql protocol
Use the qos pql inbound-interface command to establish classification rules based on interfaces.
System view
qos pql queue
Use the qos pql queue command to specify the maximum number of packets that can wait in each of the
priority queues, or the length of a PQ.
System view
qos pql protocol mpls exp
Use the qos pql protocol mpls exp command to establish the classification rule based on MPLS protocol.
System view
qos reserved-bandwidth
Use the qos reserved-bandwidth command to set the maximum reserved bandwidth percentage.
Interface view
qos rtpq
Use the qos rtpq command to enable RTP queue feature on an interface so as to reserve a real-time
service for the RTP packets sent to some UDP destination port ranges.
Interface view
qos wfq
Use the qos wfq command to apply WFQ to and configure WFQ parameters on the interface or modify
WFQ parameters on the interface.
Interface view
qos wred
Use the qos wred command to apply WRED at an interface.
Interface view
qos wred dscp
Use the qos wred dscp command to set the lower limit, upper limit, and drop probability denominator of a
WRED DSCP.
Interface view
qos wred ip-precedence
Use the qos wred ip-precedence command to configure the minimum threshold, maximum threshold and
drop probability denominator for each precedence level in WRED.
Interface view
qos wred weighting-constant
Use the qos wred weighting-constant command to set exponential used to calculate the average length
of WRED queues.
Interface view
radius nas-ip
Use the radius nas-ip command to specify the source address of the RADIUS packet sent from NAS.
System view