Filter
Top Products
140 3Com Router 5000/6000 Family
Command Reference
snmp-agent target-host
Use the snmp-agent target-host command to set the destination that receives SNMP notifications.
Use the
snmp-agent target-host command in conjunction with the snmp-agent trap enable command.
System view
snmp-agent trap enable
Use the snmp-agent trap enable command to enable the device to send traps and set the trap and
notification parameters.
System view
snmp-agent trap enable encrypt-card
Use the snmp-agent trap enable encrypt-card command to enable SNMP agent trap function on the
encryption card.
System view
snmp-agent trap enable ldp
Use the snmp-agent trap enable ldp command to enable Trap function in MPLS LDP creation.
System view
snmp-agent trap enable lsp
Use the snmp-agent trap enable lsp command to enable Trap function in MPLS LSP creation.
System view
snmp-agent trap enable mobile-ip
Use the snmp-agent trap enable mobile-ip command to enable the MIP SNMP trap function. With the
function enabled, a trap packet is sent to the network management software whenever a security violation
event occurs.
System view
snmp-agent trap enable ospf
Use the snmp-agent trap enable ospf command to enable the TRAP function of OSPF.
System view
snmp-agent trap life
Use the snmp-agent trap life command to set the lifetime of traps. The expired traps are discarded
without being retained or sent.
System view
snmp-agent trap queue-size
Use the snmp-agent trap queue-size command to set the length of the trap queue to the specified host.
System view
snmp-agent trap source
Use the snmp-agent trap source command to specify the source address of traps.
System view
snmp-agent usm-user
Use the snmp-agent usm-user command to add a new user to an SNMP group.
System view
sot counter keepalive
Use the sot counter keepalive command to specify the number of keepalive checks before disconnecting
from the peer SOT entity.
System view
sot gather
Use the sot gather command to assign the serial interface to an existing SOT protocol group.
Synchronous Serial Interface view
sot group-set
Use the sot group-set command to set up a SOT protocol group.
System view
sot peer
Use the sot peer command to assign an IP address to the local SOT entity.
System view
sot sdlc broadcast
Use the sot sdlc broadcast command to configure the broadcast address FF for the connected SDLC
terminals, allowing them to receive broadcast frames.
Synchronous Serial Interface view
sot sdlc controller
Use the sot sdlc controller command to configure the SDLC address of a connected terminal.
Synchronous Serial Interface view