Filter
Top Products
3Com Router 5000/6000 Family 135
Command Reference
sdlc window
Use the sdlc window command to configure the length of the SDLC local response window.
Synchronous Serial Interface view
sdlc xid
Use the sdlc xid command to configure the XID of the SDLC.
Synchronous Serial Interface view
secondary accounting
Use the secondary accounting command to configure the IP address and port number for the secondary
RADIUS accounting server.
RADIUS view
secondary accounting
Use the secondary accounting command to configure a secondary TACACS accounting server.
TACACS+ view
secondary authentication
Use the secondary authentication command to configure the IP address and port number of the
secondary RADIUS authentication/authorization/accounting server.
RADIUS view
secondary authentication
Use the secondary authentication command to configure a secondary TACACS authentication server.
TACACS+ view
secondary authorization
Use the secondary authorization command to configure a secondary TACACS authorization server.
TACACS+ view
security acl
Use the security acl command to set an access control list to be used by the ipsec policy and specify the
data stream protection mode.
IPSec Policy view
IPSec Policy Template view
security-policy-server
Use the security-policy-server command to specify the IP address of a security policy server.
RADIUS Scheme view
seizure-ack
Use the seizure-ack command to enable or disable the terminating point to send seizure
acknowledgement signal.
R2 CAS view
select-mode
Use the select-mode command to configure the E1 trunk selection mode.
R2 CAS view
select-rule search-stop
Use the select-rule search-stop command to configure the maximum number of voice entities found.
Voice Dial Program view
select-rule type-first
Use the select-rule type-first command to configure the type-first select rules for voice entities.
Voice Dial Program view
select-rule rule-order
Use the select-rule rule-order command to configure the select rule of voice entities.
Voice Dial Program view
select-stop
Use the select-stop command to disable the search for voice entities.
Voice Entity view
send
Use the send command to transfer messages between user interfaces.
Use the
send all command to send messages to all user interfaces.
Use the
send number command to send messages to the user interface specified by its absolute index.
Use the
send type-name number command to send messages to the user interface specified by its
interface type and relative index.
User view