Filter
Top Products
3Com Router 5000/6000 Family 81
Command Reference
impedance
Use the impedance command to configure the current electric impedance on a voice subscriber-line.
FXO Voice Subscriber-Line view
import-route
Use the import-route command to redistribute routes from other protocols.
BGP view
import-route
Use the import-route command to import routing information from other protocols to BGP.
IPv4 Multicast Subaddress Family view
import-route
Use the import-route command to configure IS-IS to filter the redistributed routes.
IS-IS view
import-route
Use the import-route command to redistribute the information of another routing protocol.
OSPF view
import-route
Use the import-route command to redistribute the routes of other protocols into RIP.
RIP view
import-route isis
Use the import-route isis level-2 into level-1 command to enable routing information in a Level-2
area to be redistributed to a Level-1 area.
IS-IS view
import-route ospf
Use the import-route ospf command to enable to import OSPF route.
BGP Unicast/Multicast view
MBGP VPN-Instance Address Family view
import-source
Use the import-source command to configure which (S, G) entries in the domain need to be advertised
when a MSDP originates an SA message.
MSDP view
info-center channel
Use the info-center channel command to assign a name to the information channel specified by
channel-number.
System view
info-center console channel
Use the info-center console channel command to have the info-center output information to the console
over the specified channel.
System view
info-center enable
Use the info-center enable command to enable the info-center.
System view
info-center logbuffer
Use the info-center logbuffer command to enable the log buffer and specify the channel for system
information output as well as the size of the log buffer.
System view
info-center logfile
Use the info-center logfile channel command to have the info-center output system information to the
log file.
System view
info-center loghost
Use the info-center loghost command to have the info-center output information to the log host.
System view
info-center loghost source
Use the info-center loghost source command to specify the source address in the packets destined to
the log host.
System view