Chapter 8 Advanced Copy Management
8.1 Advanced Copy Status
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
255
• Status
The copy session status is displayed.
- Active
Operating normally
- Reserve
Session ID reserved
- Suspend
Suspended by an instruction from the host
- Error Suspend
Copy canceled due to an error
- Unknown
A status other than the ones listed above
• Phase
The copy session phase is displayed. If the status is " Reserved", a "-" (hyphen) is displayed.
- Copying
For OPC, EC, SnapOPC, and SnapOPC+: Copying
For QuickOPC: Copying the updated areas after recording of updated areas is stopped
For Monitor: Recording the updated areas
- Equivalent
Maintaining equivalent status of the copy source and copy destination that are duplicated after copy is
complete
- Tracking
Recording only the updated area after copy is complete
- Tracking & Copy
Recording the area updated during copy processing and after copy starts
- Readying
Readying to start multiple copy using the Concurrent OPC.
• Error Code
The error code is displayed when an error occurs. If the status is " Reserved", a "-" (hyphen) is displayed.
Refer to "Appendix K Error Code" (page 1064)
for details.
• Time Stamp
The time when backup is complete and the time when an error occurred are displayed. If the status is "
Reserved", a "-" (hyphen) is displayed.
The time stamp is updated in the following conditions:
- OPC, QuickOPC, SnapOPC, and SnapOPC+
The time stamp is updated when copy starts and when an error occurs.
The following information is displayed:
• When "Status" is " Active", the backup time when the copy started is displayed.
• When "Status" is " Error Suspend", the time when the error occurred is displayed.
- QuickOPC
The time stamp is updated when copy starts, restarts, and when an error occurs.
The following information is displayed:
• When "Status" is " Active", the backup time when the copy started is displayed.
• When "Status" is " Error Suspend", the time when the error occurred is displayed.