Fujitsu DX80 S2/DX90 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
509
3 Click the [OK] button.
Changing of the FC host information starts.
4 Click the [Done] button to return to the [FC/FCoE Host] screen.
End of procedure
9.2.2.16 Modify iSCSI Host
This function changes the iSCSI host information.
An error screen appears in the following conditions:
When the "Name" is not input
When the "Name" does not satisfy the input conditions
When the "Name" already exists
When the "WWN" is not input
When the "WWN" does not satisfy the input conditions
When the same "WWN" is already registered
When there are some LUNs that cannot be recognized from the FC host because the "Host
Response" setting has been changed (only for FC hosts that are not registered in a host group)
When no iSCSI hosts are registered, the [Modify iSCSI Host] function cannot be used.
When changing the information of an iSCSI host that is currently being used, make sure to stop access to
that iSCSI host.
The [Rename iSCSI Host] function that is provided with controller firmware version V10L24 or earlier is
integrated in this function. Note that this function cannot change multiple iSCSI host names. Change one
iSCSI host name at a time.
This function can change the following iSCSI host information; "Name", "iSCSI Name", "IP Version", "IP
Address", "Alias Name", "CHAP User ID", and "CHAP Password". When the iSCSI host is not registered in a
host group, the "Host Response" setting can also be changed.
When the iSCSI host is registered in a host group, use the [Modify Host Group] function to change the host
response. Refer to "9.2.2.7 Modify Host Group (iSCSI)" (page 470)
for details.