Filter
Top Products
Chapter 3 Initial Setup
3.1 Initial Setup 1
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
39
3.1 Initial Setup 1
The flow of wizard operations in Initial Setup 1 is shown below.
(1)Set Storage Name
Register the name, administrator, and installation site of the ETERNUS DX Disk storage system. Refer to
"11.2.13.1 Modify Storage System Name" (page 927)
for details.
(2)Set Date and Time
Set the date/time and time zone (storage system location) of the internal clock in the ETERNUS DX Disk
storage system. Refer to "11.2.13.2 Modify Date and Time" (page 929)
for details.
(3)Change Password
Change the password for the default account that is currently logged in before starting to use the ETERNUS
DX Disk storage system. Refer to "11.2.1 Change User Password" (page 742)
for details.
(4)Register Thin Provisioning License
If using the Thin Provisioning function, register the license here. Refer to "7.2.10 Register Thin Provisioning
License" (page 245) for details.
(5)Register Copy License
If using the Advanced Copy function, register the license here. Refer to "8.2.4 Register Advanced Copy
License" (page 295) for details.
(6)Register SED Authentication Key
Register the Self Encrypting Drive (SED) authentication key to enable the encryption function of the SED.
Refer to "11.2.13.7 Register SED Authentication Key" (page 944)
for details
(7)Set Network Environment
Set the environment for the ETERNUS DX Disk storage system to communicate on the network such as IP
address and subnet mask. Refer to "11.2.3.1 Setup Network Environment" (page 745)
for details.
Log out when the settings are complete. Log in again, and then proceed to "3.2 Initial Setup 2" (page 49)
.
If SED has been installed before registering the SED authentication key, reboot the ETERNUS DX Disk storage
system before logging in again.