Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
763
3 Click the [OK] button.
→ Setting of the SNMP Agent basic interface starts.
4 Click the [Done] button to return to the [Network] screen.
End of procedure
11.2.3.4 Setup SNMP Manager
This function specifies the IP address of the SNMP Manager.
The SNMP Manager is used when accessing the ETERNUS DX Disk storage system using the community name
or the user name, or when sending a trap from the ETERNUS DX Disk storage system to the SNMP Manager.
Up to ten SNMP Managers can be specified for each ETERNUS DX Disk storage system.
The procedure to set the SNMP Manager is as follows:
Procedure
1 Click [Setup SNMP Manager] in [Action].
If the entered engine ID does not satisfy the input conditions, an error screen appears.
• If the "SNMP Function" is disabled, this function cannot be used.
• The IP address of the SNMP Manager that is used in the settings in "11.2.3.7 Setup SNMP Agent
Community" (page 771) or "11.2.3.8 Setup SNMP Agent Trap" (page 774) cannot be changed or deleted.
• When SNMP Manager exists in a different subnetwork from where the ETERNUS DX Disk storage system
belongs, specify the IP address or the network address of SNMP Manager in the "Allowed IP List" using the
procedure in "11.2.3.1 Setup Network Environment" (page 745)
.