Fujitsu DX80 S2/DX90 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
881
The procedure to set the event notification is as follows:
Procedure
1 Click [Setup Event Notification] in [Action].
2 Specify whether to notify each event, and click the [Set] button.
Setting based on Severity
Select whether to notify of an event by levels. Checkboxes are displayed for selectable notification
methods.
All Error Events
Select whether to notify when an error level event occurs. When notifying, select the notification
method.
By selecting or clearing the checkbox, the same setting can be applied for all the "Error Severity
Level" events.
All Warning Events
Select whether to notify when a warning level event occurs. When notifying, select the notification
method.
By selecting or clearing the checkbox, the same setting can be applied for all the "Warning Severity
Level" events.
All Informational Events
Select whether to notify when a informational level event occurs. When notifying, select the
notification method.
By selecting or clearing the checkbox, the same setting can be applied for all the "Informational
Level" events.
Individual Settings within Severity Level
"Yes" is displayed when the target notification method ("Host Sense Key Code Qualifier", "SNMP
Trap", "E-Mail", "syslog", "REMCS", or "AIS Connect") is specified for any event in "Error Severity Level",
"Warning Level", or "Informational Level", if not, "No" is displayed.
Blink Fault LED at warning
Select "Enable" when setting the Fault LED in the front panel to blink while a warning level event
occurs, and select "Disable" when setting the Fault LED not to blink.
Turn on Fault LED when redundant copy is completed
Select "Enable" when setting the Fault LED of the drive to turn on while a warning level event
occurs, and select "Disable" when setting the Fault LED not to turn on.
The events are classified into three levels: "Error Severity Level", "Warning Level", and "Informational
Level".
Click the [Setting based on Severity] tab, [Error Severity Level] tab, [Warning Level] tab or
[Informational Level] tab to display the setting fields for each level.