Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
802
● Communication Environment Information
● Detailed Configuration Information
• Data Transmission Method
Select whether to "Split" or "Do not Split" into the specified size.
Select "Split large E-mail into multiple E-mails" or "Split large data into multiple E-mails", and
specify the segment size, when segmenting outgoing mail.
If the mail server does not allow the sending of segmented mail using "Split large E-mail into
multiple E-mails", select "Split large data into multiple E-mails" or "Do not Split".
- Split
Outgoing mail is segmented. There are two methods for mail message fragmentation: "Split
large E-mail into multiple E-mails" and "Split large data into multiple E-mails".
• Split large E-mail into multiple E-mails
Outgoing mail is segmented into the specified size (64 - 6400KB).
• Split large data into multiple E-mails
The file attached to the E-mail is segmented into several pieces, turned into one E-mail in
the specified size (64 - 512KB), and sent in several transmissions.
- Do not Split
The message is sent as one E-mail without being segmented.
• Specify Storage System Name for HELO/EHLO Announcement when Sending Mail
Select "Specify" or "Do not specify" for the ETERNUS DX Disk storage system name for HELO/EHLO
announcement when sending mail.
When "Specify" is selected, enter the domain.
The following input condition applies:
- Up to 63 alphanumeric characters and symbols (except space)
The domain of the HELO/EHLO Announcement must be specified in the mail protocol.
If "Do not specify" has been selected, E-mails are sent using the strings after the "@" of the sender
mail addresses as domains.
If the mail server does not allow using the section after the "@" of the sender mail address as the
domain, select "Specify" and input the appropriate domain.
● Result notification information
• Administrator
Select "Notification" or "Not Notification" for the customer manager of the setting confirmation
result at the REMCS center.
Select "Notification" for the "Administrator" or the "Connection check operator" and confirm the
result.
Refer to Step 2 in the "11.2.4.4 Update Communication Environment Information" (page 808) for
setting items.