Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
761
11.2.3.3 Setup SNMP Agent Basic Interface
This function sets up the SNMP Agent basic interface in the ETERNUS DX Disk storage system.
SNMP is a standard protocol used for network management.
The procedure to set the basic information of SNMP Agent is as follows:
Procedure
1 Click [Setup SNMP Interface] in [Action].
2 Specify the parameters, and click the [Set] button.
• SNMP Function
Select whether to enable or disable the SNMP function.
• When SNMP Manager exists in a different subnetwork from where the ETERNUS DX Disk storage system
belongs, specify the IP address or the network address of SNMP Manager in "Allowed IP List" using the
procedure in "11.2.3.1 Setup Network Environment" (page 745)
.
• Before enabling the SNMP function, use the procedure in "11.2.3.2 Setup Firewall" (page 758)
to allow
the "SNMP" connection for the setting target LAN port.
• By using the procedure in "Chapter 3 Initial Setup" (page 38), the SNMP Agent environment can be
configured with the wizard. When the [Initial Setup] function is not used, configure the SNMP Agent
environment in the following order:
- When using SNMPv1 or SNMPv2c for SNMP communication
(1)Setup SNMP Agent Basic Interface
(2)Setup SNMP Manager
(3)Setup SNMP Agent MIB Access View
(4)Setup SNMP Agent Community
(5)Setup SNMP Agent Trap
- When using SNMPv3 for SNMP communication
(1)Setup SNMP Agent Basic Interface
(2)Setup SNMP Manager
(3)Setup SNMP Agent MIB Access View
(4)Setup SNMP Agent User
(5)Setup SNMP Agent Trap
• The parameter settings specified using this function remain even when the "SNMP Function" setting is
changed from "Enable" to "Disable".