Fujitsu DX80 S2/DX90 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 10 Component Management
10.1 Component Status
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
692
The following items are displayed in the Main area:
CM#x CA#y Port#z Information
- Location
The location information of the port is displayed.
CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
- Port Mode
The port mode (fixed to "CA") is displayed.
- Status
The port status is displayed. Refer to "B.5 Component Status" (page 977)
for details.
- Status Code
The port status code is displayed.
- Error Code
The port error code is displayed.
- Type
The type of the port (fixed to "FCoE") is displayed.
- Connection
The connection type of the port is displayed.
Fabric
A connection type that enables simultaneous communication among multiple nodes through a
Fibre Channel switch.
FC-AL
A connection type that connects multiple nodes in a loop.
- Transfer Rate
The transfer speed of the port (fixed to "10 Gbit/s") is displayed.
If the status is " Unknown", a "-" (hyphen) is displayed.
- Link Status
The link status of the port is displayed.
If the status is " Unknown", a "-" (hyphen) is displayed.
Link Down
10Gbit/s Link Up
- WWN
The WWN of the port is displayed.
- Affinity Mode
The affinity mode of the port is displayed.
ON
OFF
- FC Frame Size
The frame size of the port is displayed.
512 byte
1024 byte
2048 byte
- VLAN ID
The VLAN ID is displayed.
When the VLAN ID is manually specified, the VLAN ID is displayed between 0 - 4095.
When the VLAN ID is automatically specified, "Auto" is displayed.