Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
781
11.2.3.12 Setup E-Mail Notification
This function is used to configure the E-mail Notification settings for the various events detected by the
ETERNUS DX Disk storage system.
To specify event notification, refer to "11.2.9.1 Setup Event Notification" (page 880)
.
The procedure to set a E-Mail notification is as follows:
Procedure
1 Click [Setup E-Mail Notification] in [Action].
2 Specify the parameters, and click the [Set] button.
● Notification E-Mail
• Notification E-Mail
Select whether to enable ("Yes") or disable ("No") the E-Mail notification function.
• Destination E-Mail Address
Specify the E-Mail destination address.
At least one address must be specified. Up to five addresses can be specified.
The following input condition applies:
- Up to 63 alphanumeric characters and symbols (except spaces)
• Comment
Input the message (comment) to be added to the E-Mail. The comment can be omitted.
The following input conditions apply:
- Up to 225 characters
- Within ten lines
- Alphanumeric characters, symbols, and spaces
● Mail Server Settings
• LAN Port used for SMTP Connection
Select the LAN port connecting to the SMTP server from "MNT" or "RMT".
• Sender E-Mail Address
Input the E-Mail address of the ETERNUS DX Disk storage system.
The following input condition applies:
- Up to 63 alphanumeric characters and symbols (except spaces)
When stopping the event notification via E-Mail, perform one of the following procedures.
• Disable the "Notification E-Mail"
• Clear the E-Mail checkbox of the notification method using the procedure in "11.2.9.1 Setup Event
Notification" (page 880).