Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
825
4 Click the [OK] button.
→ AIS Connect setting starts.
5 Click the [Done] button to return to the screen when starting this function in Step 1.
End of procedure
11.2.5.2 Setup Remote Session Permission
This function performs permission settings for remote sessions with the AIS Connect function. If a remote ses-
sion is permitted, remotely controlling the ETERNUS DX80 S2/DX90 S2, ETERNUS DX410 S2/DX440 S2, or ETER-
NUS DX8100 S2/DX8700 S2 from a remote server (AIS Connect server) becomes available.
The procedure to set the remote support permission is as follows:
Procedure
1 Click [Setup Remote Session Permission] in [Action].
• Settings can be changed when "AIS Connect" is enabled. Refer to "11.2.5.1 Setup AIS Connect
Environment" (page 821) for details.
• The permission setting of a remote session is released if one of the following conditions applies:
- When a remote session is not detected before the timeout period that is specified for the timeout
setting
- When this function forbids remote sessions
- When "AIS Connect" is disabled
• The permission settings are retained even if the ETERNUS DX Disk storage system is rebooted or after
recovery from a power failure. Note that the timer that monitors remote session connection is reset to
"0"in this case.
• If the setting of this function is changed to forbid while a remote session is being performed, operations
for this remote session are permitted until the user logs out. However, once this remote session is logged
out from, this remote session cannot be logged into while the remote session is forbid.
• When "AIS Connect" is disabled, all remote sessions that are currently being performed are immediately
disconnected.