Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
126
config traffic control_trap
Purpose
Used to configure traffic control trap.
Syntax
config traffic control_trap [none | storm_occurred | storm_cleared |
both]
Description
This command is used to configure whether storm control
notification will be generated or not when traffic storm events are
detected by the SW traffic storm control mechanism. Note: A traffic
control trap is active only when the control action is configured as
“shutdown”. If the control action is “drop,” there will no traps issued
when a storm event is detected.
Parameters
none – No notification will be generated when a storm event is
detected or cleared.
storm _occurred – A notification will be generated when a storm
event is detected.
storm_cleared − A notification will be generated when a storm event
is cleared.
both − A notification will be generated both when a storm event is
detected and cleared.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure traffic control for both:
DES-3200-28:4#config traffic control_trap both
Command: config traffic control_trap both
Success.
DES-3200-28:4#