xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
458
config ethernet_oam ports (received remote loopback)
Purpose
Used to configure the method to process the received Ethernet OAM remote loopback
command.
Syntax
config ethernet_oam ports [ <portlist> | all ] received_remote_loopback [ process | ignore ]
Description
The command is used to configure the client to process or to ignore a received Ethernet OAM
remote loopback command.
In remote loopback mode, user traffic is not forwarded on the port. If ignore is specified for
received_remote_loopback, the specified port will ignore all requests to transition to remote
loopback mode and prevent the Switch from entering remote loopback mode, thus it continues to
process user traffic regardless.
Parameters
<portlist> - Specifies a range of ports to be configured. Use all to specify all ports.
received_remote_loopback - Specify whether to process or ignore the received Ethernet OAM
remote loopback command.
ignore – The port disregards requests to change to remote loopback mode and continues to
forward user traffic.
process – The port will accept and process requests to change to remote loopback mode,
meaning that it will discontinue forwarding user traffic if it receives a remote loopback mode
request.
The default method is “ignore”.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure the method of processing the received remote loopback command as “process” on port 1:
DES-3200-28F:4# config ethernet_oam ports 1 received_remote_loopback
process
Commands: config ethernet_oam ports 1 received_remote_loopback process
Success
DES-3200-28F:4#
show ethernet_oam ports (status)
Purpose
Used to display primary controls and status information for Ethernet OAM per port.
Syntax
show ethernet_oam ports {<portlist>} status
Description
The command used to show primary controls and status information for Ethernet OAM on
specified ports.
The information includes:
(1) OAM administration status: enabled or disabled
(2) OAM operation status. It maybe the below value:
• Disable: OAM is disabled on this port
• LinkFault: The link has detected a fault and is transmitting OAMPDUs with a link
fault indication.
• PassiveWait: The port is passive and is waiting to see if the peer device is OAM
capable.
• ActiveSendLocal: The port is active and is sending local information
• SendLocalAndRemote: The local port has discovered the peer but has not yet
accepted or rejected the configuration of the peer.