xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
346
config lldp ports dot1_tlv_pvid
from outbound LLDP advertisements.
Syntax
config lldp ports [<portlist>|all] dot1_tlv_pvid [enable | disable]
Description
This TLV optional data type determines whether the IEEE 802.1
organizationally defined port VLAN TLV transmission is allowed on a
given LLDP transmission capable port.
Parameters
<portlist> - Specify a range of ports to be configured.
all - To set all ports in the system, use the “all” parameter.
dot1_tlv_pvid - This TLV optional data type determines whether the IEEE
802.1 organizationally defined port VLAN ID TLV transmission is allowed
on a given LLDP transmission capable port. The default state is disable.
Restrictions
Only Administrator-level users can issue this command.
Example usage
To configure the VLAN name TLV from the outbound LLDP advertisements for all ports:
DES-3200-28:4# config lldp ports all dot1_tlv_pvid enable
Command: config lldp ports all dot1_tlv_pvid enable
Success.
DES-3200-28:4#
config lldp ports dot1_tlv_protocol_vid
Purpose
Used to configure an individual port or group of ports to exclude one or
more of IEEE 802.1 organization protocol identity TLV data types from
outbound LLDP advertisements.
Syntax
config lldp ports [<portlist>|all] dot1_tlv_protocol_vid [vlan [all | all
<vlan_name 32> ] | vlanid <vlanid_list> ] [enable | disable]
Description
This TLV optional data type indicates whether the corresponding Local
System's Protocol Identity instance will be transmitted on the port. The
Protocol Identity TLV provides a way for stations to advertise protocols
that are important to the operation of the network. Such as Spanning
Tree Protocol, the Link Aggregation Control Protocol, and numerous
vendor proprietary variations which are responsible for maintaining the
topology and connectivity of the network. If EAPOL, GVRP,
STP(including MSTP), and LACP protocol identity is enabled on this port
and it is enabled to be advertised, then this protocol identity will be
advertised.
Parameters
<portlist> - Specify a range of ports to be configured.
all - To set all ports in the system, use the “all” parameter.
dot1_tlv_protocol_vid - This TLV optional data type determines whether
the IEEE 802.1 organizationally defined port VLAN ID TLV transmission
is allowed on a given LLDP transmission capable port. The default state
is disabled.
vlanid_list – A list of VIDs to be configured for this command.
Restrictions
Only Administrator-level users can issue this command.
Example usage
To configure the VLAN name TLV from the outbound LLDP advertisements for all ports: