D-Link DES-3200 Switch User Manual


 
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
306
38
VLAN TRUNKING COMMANDS
The VLAN Trunking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist>|all] state [enable|disable]
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose
Used to enable the VLAN trunk function.
Syntax
enable vlan_trunk
Description
When the VLAN trunk function is enabled, the VLAN trunk ports shall be
able to forward all tagged frames with any VID.
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To enable the VLAN Trunk:
DES-3200-28:4#enable vlan_trunk
Command: enable vlan_trunk
Success.
DES-3200-28:4#
disable vlan_trunk
Purpose
Used to disable the VLAN trunk function.
Syntax
disable vlan_trunk
Description
This command is used to disable the VLAN trunk function.
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To disable the VLAN Trunk:
DES-3200-28:4#disable vlan_trunk
Command: disable vlan_trunk
Success.
DES-3200-28:4#