Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
484
config erps log
Syntax
config erps log [enable | disable]
Description
This command is used to enable or disable logging of ERPS events.
Parameters
enable | disable – Use to define the status of ERPS logging. Logging is disabled by
default.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To enable the ERPS logging function:
DES-3200-28F:4# config erps log enable
Command: config erps log enable
Success.
DES-3200-28F:4#
show erps
Purpose
Used to display ERPS information.
Syntax
show erps
Description
This command is used to display ERPS configuration and operation information.
The port state of the ring port may be as "Forwarding", "Blocking", "Signal Fail".
"Forwarding" indicates that traffic is able to be forwarded. "Blocking" indicates that traffic is
blocked by ERPS and a signal failure is not detected on the port. "Signal Fail" indicates
that a signal failure is detected on the port and traffic is blocked by ERPS.
The RPL owner administrative state could be configured to "Enabled" or "Disabled". But
the RPL owner operational state may be different from the RPL owner administrative
state, for example, the RPL owner conflict occurs. "Active" is used to indicate that the RPL
owner administrative state is enabled and the device is operated as the active RPL owner.
"Inactive" is used to indicate that the RPL owner administrative state is enabled, but the
device is operated as the inactive RPL owner.
Parameters
None.
Restrictions
None.