Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
439
show cfm fault
Description
This command displays all the fault conditions detected by the MEPs contained in the specified MA
or MD.
This display provides the overview of the fault status by MEPs.
Parameters
ma <string 22> - The name of the maintenance association (MA) to view faults for MEPs.
md <string 22> - The name of the maintenance domain (MD) to view faults for MEPs.
Restrictions
None.
Example usage
To view all MEP faults:
DES-3200-28F:4# show cfm fault
Command: show cfm fault
MD Name MA Name MEPID Status
----------- ----------- ----- ---------------------------
op_domain op1 1 Cross-connect CCM Received
DES-3200-28F:4#
show cfm port
Purpose
This command is used to show MEPs and MIPs created on a port.
Syntax
show cfm port <port> {level <int 0-7> | direction [ inward | outward ] | vlanid <vlanid 1-4094>}
Description
This command is used to show the MEPs and MIPs created on a port.
Parameters
port <portlist> - The port for which to display CFM configuration.
level <int 0-7> - Setting level of the MD to be shown. If not specified, all levels are shown.
direction – The direction of the MEP to be displayed.
inward - Inward facing (up) MEP only are displayed.
outward - Outward facing (down) MEP only are displayed.
If not specified, both directions and the MIP are shown.
vlanid <vlanid 1-4094> - VLAN identifier for settings displayed. If not specified, all VLANs are
shown.
Restrictions
None.