Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
230
Example usage:
To manually set system time and date settings:
DES-3200-28:4#config time 30jun2003 16:30:30
Command: config time 30jun2003 16:30:30
Success.
DES-3200-28:4#
config time_zone
Purpose
Used to determine the time zone used in order to adjust the system
clock.
Syntax
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
Description
This command is used to adjust system clock settings according to
the time zone. Time zone settings will adjust SNTP information
accordingly.
Parameters
operator – Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour – Select the number of hours different from GMT.
min – Select the number of minutes that need to be added or
subtracted to adjust the time zone.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure time zone settings:
DES-3200-28:4#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DES-3200-28:4#
config dst
Purpose
Used to enable and configure time adjustments to allow for the use of
Daylight Savings Time (DST).
Syntax
config dst [disable | repeating {s_week <start_week 1-5,last> | s_day
<start_day sun-sat> | s_mth <start_mth 1-12> | s_time start_time hh:mm> |
e_week <end_week 1-5,last> | e_day <end_day sun-sat> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} |
annual {s_date start_date 1-31> | s_mth <start_mth 1-12> | s_time
<start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
Description
DST can be enabled and configured using this command. When enabled
this will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time
set using SNTP service.