Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
72
show config
Purpose
Used to display the current or saved version of the configuration settings of the
switch.
Syntax
show config [current_config | config_in_nvram]
Description
This command is used to display all the configuration settings that are saved to
NVRAM or display the configuration settings as they are currently configured. Use
the keyboard to list settings one line at a time (Enter), one page at a time (Space)
or view all (a).
The configuration settings are listed by category in the following order:
Basic (serial port, Telnet and web
management status)
storm control
IP group management
Syslog
QoS
port mirroring
traffic segmentation
port
port lock
8021x
SNMPv3
management (SNMP traps RMON)
VLAN
FDB (forwarding data base)
MAC address table notification
STP
SSH
SSL
ACL
SNTP
IP route
LACP
ARP
IP
IGMP snooping
access authentication control (TACACS
etc.)
PoE
Bandwidth
Time_range
GM
safeguard_engine
Banner_promp
SMTP
AAA
DHCP_Relay
Parameters
current_config – Entering this parameter will display configurations entered without
being saved to NVRAM.
config_in_NVRAM − Entering this parameter will display configurations entered and
saved to NVRAM.
Restrictions
Only Administrator-level users can issue this command.