D-Link DES-3200 Switch User Manual


 
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
265
DES-3200-28:4#show authen server_group
Command: show authen server_group
Group Name IP Address Protocol
----------- ----------------------------- ------------
radius ---------------------------------------------
tacacs ---------------------------------------------
tacacs+ ---------------------------------------------
xtacacs ---------------------------------------------
Total Entries : 4
DES-3200-28:4#
config authen parameter response_timeout
Purpose
Used to configure the amount of time the Switch will wait for a user to
enter authentication before timing out.
Syntax
config authen parameter response_timeout <int 0-255>
Description
This command is used to set the time the Switch will wait for a response
of authentication from the user.
Parameters
response_timeout <int 0-255> Set the time, in seconds, the Switch will
wait for a response of authentication from the user attempting to log in
from the command line interface or telnet interface. 0 means there won’t
be a time-out. The default value is 30 seconds.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure the response timeout for 60 seconds:
DES-3200-28:4#config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
DES-3200-28:4#
config authen parameter attempt
Purpose
Used to configure the maximum number of times the Switch will accept
authentication attempts.
Syntax
config authen parameter attempt <int 1-255>
Description
This command is used to configure the maximum number of times the
Switch will accept authentication attempts. Users failing to be
authenticated after the set amount of attempts will be denied access to
the Switch and will be locked out of further authentication attempts.
Command line interface users will have to wait 60 seconds before
another authentication attempt. Telnet users will be disconnected from
the Switch.
Parameters
parameter attempt <int 1-255> Set the maximum number of attempts
the user may try to become authenticated by the Switch, before being
locked out.
Restrictions
Only Administrator-level users can issue this command.
Example usage: