Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
457
config ethernet_oam ports (remote loopback)
Purpose
Used to start or stop Ethernet OAM remote loopback mode for the remote peer of the port.
Syntax
config ethernet_oam ports [<portlist> | all ] remote_loopback [ start | stop ]
Description
The command is used to start or stop the remote peer to enter Ethernet OAM remote loopback
mode.
To start the remote peer to enter remote loopback mode, the port must be in active mode and
the OAM connection established.
If the local client is already in remote loopback mode, then the command cannot be applied.
Parameters
<portlist> - Specifies a range of ports to be configured. Use all to specify all ports.
remote_loopback - If start is specified, a request is sent to the remote peer to change to
remote loopback mode. If stop is specified, a request is sent to the remote peer to change to
normal operation mode.
Restrictions
Only Administrator-level users can issue this command.
Example usage
To start remote loopback on port 1 of unit 1:
DES-3200-28F:4# config ethernet_oam ports 1 remote_loopback start
Commands: config ethernet_oam ports 1 remote_loopback start
Success
DES-3200-28F:4#