Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
26
show config
Purpose
Used to collect and display all system configurations in a single CLI
command.
Syntax
show config [current_config | config_in_nvram]
Description
This command is used to display all system configurations. The
continuous displaying configuration can be aborted by the interrupt
key, which may be a sequence of a keying process or a single key.
The display format should be the same as the CLI configuration
command.
Parameters
current_config – Display system configuration from the DRAM
database, i.e. the current system setting.
config_in_nvram – Display the system configuration from NV-RAM.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To display all system configurations from the DRAM database:
DES-3200-28:4#show config config_in_nvram
Command: show config config_in_nvram
#-------------------------------------------------------------------
# DES-3200-28 Configuration
#
# Firmware: Build 1.28.005
# Copyright(C) 2010 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------
# BASIC
config serial_port baud_rate 9600 auto_logout 10_minutes
# ACCOUNT LIST
# ACCOUNT END
# PASSWORD ENCRYPTION
disable password encryption
config terminal_line default
enable clipaging
# STORM
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
Note: If the downloaded configuration file has been modified and saved, the “From” item will
display “local save.”