Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
35
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax
show ports {<portlist>} {[description | err_disabled]}
Description
This command is used to display the current configurations of a range of ports. No
parameters will show all ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
description – Adding this parameter to the show ports command indicates that a
previously entered port description will be included in the display.
err_disabled – Use this to list disabled ports including connection status and
reason for being disabled.
Restrictions
None.
Example usage:
To display the configuration of all ports on a standalone switch:
DES-3200-28:4#show ports
Command show ports
Port State/ Settings Connection Address
MDI Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
----- -------- --------------------- --------------------- --------
1 Enabled 100M/Full/Disabled LinkDown Enabled
2 Enabled 100M/Full/Disabled LinkDown Enabled
3 Enabled 100M/Full/Disabled LinkDown Enabled
4 Enabled 100M/Full/Disabled LinkDown Enabled
5 Enabled 100M/Full/Disabled LinkDown Enabled
6 Enabled 100M/Full/Disabled LinkDown Enabled
7 Enabled 100M/Full/Disabled LinkDown Enabled
8 Enabled 100M/Full/Disabled LinkDown Enabled
9 Enabled 100M/Full/Disabled LinkDown Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh