Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
481
config erps rpl
Purpose
Used to define the RPL port or the RPL owner status for a specific R-APS VLAN.
Syntax
config erps raps_vlan <vlanid> [ rpl_port [west | east | none] | rpl_owner [enable |
disable] ]
Description
This command is used to configure the RPL port and the RPL owner in an R-APS
VLAN. Use rpl_port to define the west or east port as an RPL port. To remove the
RPL port status, use rpl_port none to indicate that neither the west or east port are
RPL ports.
Use rpl_owner to designate the node as the RPL owner. RPL owner status can be
enabled or disabled.
ERPS must first be globally disabled to modify the RPL owner or RPL port
configuration.
Parameters
raps_vlan <vlanid> - Designates the VLAN identified by the vlanid as the R-APS
VLAN where the node is being configured.
port – Define the west or east port as an RPL port; or remove RPL status from the
node by specifying none.
Default setting, the node does not have an RPL port.
rpl_owner - Used to determine RPL owner status.
enable - Designates the device as an RPL owner node.
disable - This node is not an RPL owner.
By default, the RPS owner is disabled.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To define RPL owner status for the west port of R-APS VLAN 4094:
DES-3200-28F:4# config erps raps_vlan 4094 rpl port west owner enable
Command: config erps raps_vlan 4094 rpl port west owner enable
Success.
DES-3200-28F:4#