D-Link DES-3200 Switch User Manual


 
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
261
DES-3200-28:4#config a
uthen server_host 10.1.1.121 protocol tacacs+ port
4321 timeout 12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol tacacs+ port 4321
timeout 12 retransmit 4
Success.
DES-3200-28:4#
delete authen server_host
Purpose
Used to delete a user-defined authentication server host.
Syntax
delete authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
Description
This command is used to delete a user-defined authentication
server host previously created on the Switch.
Parameters
server_host <ipaddr> The IP address of the remote server host to
be deleted.
protocol – The protocol used by the server host the user wishes to
delete. The user may choose one of the following:
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
xtacacs Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ Enter this parameter if the server host utilizes the
TACACS+ protocol.
radius Enter this parameter if the server host utilizes the RADIUS
protocol.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To delete a user-defined TACACS+ authentication server host:
DES-3200-28:4#delete authen server_host 10.1.1.121 protocol tacacs+
Command: delete authen server_host 10.1.1.121 protocol tacacs+
Success.
DES-3200-28:4#
show authen server_host
Purpose
Used to view a user-defined authentication server host.
Syntax
show authen server_host
Description
This command is used to view user-defined authentication server
hosts previously created on the Switch.
The following parameters are displayed:
IP Address – The IP address of the authentication server host.
Protocol – The protocol used by the server host. Possible results will
include TACACS, XTACACS, TACACS+ or RADIUS.